Powder coating application equipment

It has pulse and one-touch intelligent function, and is good for flat parts, complex parts, recoat parts and conner.

Flat model:  maximizes voltage for superior transfer efficiency with coating flats parts.

Complex model: adjust the voltage while holding current when coating complicated shapes and corners.

Recoat model: adjust the voltage and current automatically for recoating of parts.

Pulse model: rapidly recharges the powder to coat complex shapes.

1. ^{Quick and simple color change}

2. ^{Enhanced coating quality of flat and complex parts
   • Reduced operator fatigue
   • Effective coating in corners and recesses
   • Improved recoating ability}

Special features

1.Colo Newly integrated technology can lead to powder savings due to excellent transfer efficiency, easily penetrating corners

2.Colo Anti-static powder hose is developed with colo technology and it can prevent risk of fire by removing spark or electrical arc.

3.Prevents safety accidents caused by electrostatic shocks to the worker.

4.The new technology of one touch button installed in the gun enables you to clean inside of the gun and powder hose easily and quickly.

-INSTALLATION

→Propery ground all equipment in the spray area to an earth ground and maintain this ground

→Remove all containers of volatiles from the spray area

→Establish and maintain a grounded area for the spray operator

→The gun of xseries must be connect to xcontrol unit

→OPERATION

→The operator should hold the gun in his bare hand

→If gloves are worm ,the palm should be out to assure skin to metal contact

→The operator should wear shoes with conductive shoes e.g leather

     Rubber shoes are not conductive .

→Ground the tip of the gun before cleaning or changing nozzles.

→When the gun is not in use , it should be hung so that the nozzle is within four inches of a grounded conductor

→The operator should wear a filter-type respiator anytime he is exposed to dusty conditions

→High pressure powder many cause injury ,Keep the rear switch  “off” position in no –use condiction

  MAINTENANCE

→Make a periodic confirmation of grounding to earh of all equipment in the spray area .

→Exercise good housekeeping practices , do not allow dirt or powder to accumulate on the feeder /powder unit , cable or gun.

→Keep the cabinet door