High quality no wear three phase motor automatic powder coating reciprocator

Advantages  and characteristics:

1.The high-quality import transducer

2.It is driven by non-abrasion three-phase motor and repair is simple.

3.The travel and speed are easy for alteration together with the settings.

4.The machine is applicable for powder spray,paint spray and spray of work-pieces with high

standard.

5.The complete control program of the machine will guarantee accurate orientation.

Technical Data

General information

Maximum available programs	80
Max stoke height	2.8m
Maximum speed	0.8m/s
Minimum speed	0.08m/s
acceleration	0.1m/s2

Electrical data

Nominal input voltage	170-264VAC single phase
Tolerance	+10%/-10%
frequency	50/60hz
Fuse	10.0AT
Power consumption	2.5kw

Dimensions

width	0.7M
Depth	0.7M
Height(1.5M/2M/2.5M)	2.4/2.9/3.4M
weight	150kgs

Installation Instructions
1) Wire connecting guiding:

1. Make sure it is grounded well before using ,the resistor＜100 Ohm.

2. Reciprocator must controlled by the single phase power ,and it can be cut off at any time.

2)Machinery install:

Temperature:  -10℃ ～ +50℃

Altitude:  ＜1500m

Attack :avoid attack on the control unit

Shaking :do not put the control unit on the shaking place.

electromagnetic interference :do not put the control unit on the place that is around the electromagnetic source.

Air pollution: do not put the control unit on the place that is full with dust or corrosive air ,prevent the dust come into the control unit.

Moisture: do not put the control unit on the moisture place.

Level: the track on the ground need on the standard level ,tight it with expansion bolt.

Display and input buttons

Display	Description
A1	Light NO1
A2	Light NO2
A3	Upward moving----see PIC 01
A4	Downward moving---See PIC 02
A5	Auto model
B1	Actual value
B2	Program mode
B3	Manual/auto swich key
C1	Top stroke setting
C2	Bottom stroke setting
C3	Speed setting
D1	Manual model switch
D2	Power switch OFF

Note:D1  it is not only for star, and it is key for save program setting

Press B3 till the A5 is not flash any more(red)—auto working model

Press B3 till the A5 is turn off--- manual working model

When in auto working model, it is controller by power ,in other words when you connect the power , it will work automatic without press any key

When in manual model ,after connected the power , you should press D1

the host machine

 front view